run out during printing.
Ink tank not
installed.
[1660] U043 The following ink
tank cannot be
recognized.
(Applicable ink tank
icon)
Install the applicable ink
tank(s) properly, and
confirm that the LED's of
all the ink tanks light red.
- Ink tank
- Carriage unit
Print head not
installed, or not
properly
installed.
[1401] U051 Print head is not
installed. Install the
print head.
Install the print head
properly.
If the error is not cleared,
confirm that the print head
contact pins of the carriage
are not bent.
- Print head
- Carriage unit
Faulty print
head ID.
U052 The type of print head
is incorrect. Install the
correct print head.
Re-set the print head. If the
error is not cleared, the
print head may be
defective. Replace the print
head. If the error is not
cleared, confirm that the
print head contact pins of
the carriage are not bent.
- Print head
- Carriage unit
Print head
temperature
sensor error.
[1403]
Faulty
EEPROM data
of the print
head.
[1405]
Multiple ink
tanks of the
same color
installed.
[1487] U071 More than one ink
tank of the following
color is installed.
Replace the wrong ink tank
(s) with the correct one(s).
- Ink tank
Ink tank in a
wrong position.
[1680] U072 Some ink tanks are
not installed in place.
Install the ink tank(s) in
the correct position.
- Ink tank
Warning: The
ink absorber
becomes almost
full.
[1700] --- The ink absorber is
almost full. Press
[OK] to continue
printing. Contact the
service center.
Replace the ink absorber,
and reset its counter. [See
3-3, Adjustment and
Settings in Service Mode.]
Pressing the OK button
will exit the error, and
enable printing without
replacing the ink absorber.
However, when the ink
absorber becomes full, no
further printing can be
performed unless the
applicable ink absorber is
replaced.
- Absorber kit
The connected
digital camera
or digital video
camera does not
[2001] --- Incompatible device
detected. Remove the
device.
Remove the cable between
the camera and the
machine.
To Next Page
Loading...
