79
Setting Display Status
Setting Up Functions from Menus
Select HDMI Over Scan
[HDMI over scan]
You can select this as required when you
project visual software with the HDMI sig-
nals.
Press the OK button to accept your setting
and then press the MENU button.
• [On] is the factory default.
Performing Progressive Processing
[Progressive]
You can select this as required when the
images have low resolution.
Press the OK button to accept your setting
and then press the MENU button.
• [Auto] is the factory default.
• You can set this mode for either [HDMI],
[COMPONENT], [VIDEO] or [S- VIDEO].
• Select [Off] when flickers and horizontal
lines are noticeable on a fast-moving
picture.
• For the details of the progressive pro-
cessing, refer to the page 137.
HDMI COMPONENT
DIGITAL PC
VIDEO/S-VIDEO
ANALOG PC USB
Off The entire input signals (100%) are pro-
jected.
The images projected may be smaller
than the full projection screen.
On Images are projected with disorders at
their peripheral section of images
trimmed off. (The central 95% of the
images are projected.)
A part of peripheral sections of images
may be cut out depending on the resolu-
tion of the signals. In such a case, select
[Off].
HDMI over scan
Display settings
HDMI COMPONENT
DIGITAL PC
VIDEO/S-VIDEO
ANALOG PC USB
Off Do not perform the progressive pro-
cessing.
On Perform the progressive processing.
This mode is available when the
HDMI signal is 1080i or, VIDEO/S-
VIDEO or COMPONENT signal is
1080i, 1035i, 576i, or 480i.
Auto Perform the appropriate progressive
processing depending on the input
signal.
Progressive
Display settings
To Next Page
Loading...
Need help?
General
