Canon w-e1 - Page 81

81
Responding to Error Messages
 Are the camera and the access point set to use the same
authentication method?
 The camera supports the following authentication methods: [Open
system], [Shared key], and [WPA/WPA2-PSK] (p.36).
 Are the camera and the access point set to use the same
encryption key for authentication?
 The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct encryption key for
authentication is set on the camera (p.47).
 If filtering by MAC address is active, is the MAC address of the
W-E1 used registered at the access point?
 Register the MAC address of the W-E1 used at the access point.
The MAC address can be checked on the [General sett.] screen
(p.72).
 Are the camera and the access point set to use the same
encryption method?
 The camera supports the following encryption methods: WEP,
TKIP, and AES (p.36).
 If filtering by MAC address is active, is the MAC address of the
W-E1 used registered at the access point?
 Register the MAC address of the W-E1 used at the access point.
The MAC address can be checked on the [General sett.] screen
(p.72).
63: Wireless LAN authentication failed
64: Cannot connect to wireless LAN terminal