1. Have an appropriate oil drain pan.
2. Remove the back panel. (Page 35)
3. Remove the drain plug to drain the oil.
4. Put the drain plug back in place and tighten it
securely.
• Oil Capacity: 2.0L (2.11 US qts.)
1. Park the machine on a level ground.
2. Remove the inspection plug and inspect if
the oil level is at the inspection hole. Fill oil if
the level is low.
3. Visually inspect the condition of the oil. If
dirty, change it.
4. Visually inspect the seal washer on the
inspection plug.
5. Clea n t h e i n s p e c t i o n p lu g a n d s e a l
washer. Put the inspection plug back in the
inspection hole and tighten it securely.
1. Remove the back panel. (Page 35)
2. Remove the ller cap and ll a sufcient
amount of oil.
3. Inspect the oil level.
4. Put the ller cap back in place.
5. Install the back panel. (Page 35)
To Next Page
Loading...
