Fuses
1. Open the engine hood and hold it in place
with the engine hood stay.
2. Take the lid off the fuse housing.
3. Locate the blown fuse and replace it with a
new one of the correct rating.
4. Put the lid back in place.
5. Undo the engine hood stay and close the
engine cover.
• If a fuse blows, investigate the cause before replacing. Always replace a fuse
with the one of the correct rating.
7. When the battery is fully charged, put the
ller plugs back in place and install the
battery.
8. Connect the (+) cable from the terminal.
9. Connect the (-) cable from the terminal.
10. Install the right side and back panels. back in
place.
• Consider rapid charging as an emergency measure. This method uses a large
amount of current to compensate the lost charge in a short time. However, the
battery needs to be fully charged in the ordinary method for a longer service life.
NOTE
To Next Page
Loading...
