1. Park the machine on a level ground.
2. Lift the bucket and hold the bucket with the
safety prop. (Page 26) Lock the dump lever
with lock plate.
3. Remove the front panel. (Page 36)
4. Undo the bolts and remove the suction lter
mount.
• Replace both the line lter cartridge and the suction lter element when hydraulic
uid is changed.
NOTE
Changing Suction Filter
Transmission Oil
• Always park the machine on a level surface and block the tracks with chocks
when working under the machine.
• Replace both the line lter cartridge and the suction lter element when hydraulic
uid is changed.
• Do not use the lter wrench when tightening the lter cartridge. Tighten it by hand.
NOTE
5. Unfasten the suction lter with a wrench and
install a new lter. Tighten it securely.
6. Coat the O-ring with hydraulic uid evenly
and insert the suction lter mount inthe tank.
Make sure to insert it straight so that the
O-ring does not get out of the groove. Fasten
the suction lter mount with bolts.
7. Install the front panel. (Page36)
8. Undo the safety prop. Lower the bucket.
To Next Page
Loading...
