Instruction manual CE1122
Please keep this instruction manual for future reference
8
INSTALLATION
NOTE: Two people are needed for the installation of this product.
It is possible to open the glass/steel panels, which cover the grease filters, by slightly
pulling the panel on a side, as shown on fig.1 In order to allow the hood to perform
correctly, it is recommended to install the appliance at a distance of 2000 - 2100
mm from the floor. Before starting the appliance installation, please check that
all components are not damaged, in such a case contact your retailer and do not
carry out the installation. Furthermore, please read carefully all of the following
installation instructions.
- For the best performance we recommend an exhausting pipe with a maximum
length not exceeding 5 meters.
- Limit the number of elbows in the piping, since each elbow reduces the air
capacity of 1 linear meter. (Eg. if you use 2 x 90° elbows, the length of piping
should not exceed 3 meters).
- Avoid abrupt direction changes.
- Use a 150 mm constant diameter pipe for the whole length.
- Use ducting approved by the local standards inforce.
NOTE: For more information on venting, please see our ‘Extraction & Ventilation
guide’ available on our website www.caple.co.uk.
CE1122SS/WH_Instruction manual.indd 8 22/03/2018 10:53
To Next Page
Loading...
