Instruction manual CE1122
Please keep this instruction manual for future reference
9
FREESTANDING INSTALLATION
Recirculating version
The product is ready for this version.
Attention:
Let the power cord pass through the hood hole, as shown in fig. 2.
Mark the holes to fix the product to the false ceiling.
Having marked the holes, make them by using a drill bit (diameter 8mm), and place
in the holes the metric fixing plugs provided.
Open the glass panels, following the instructions mentioned in the previous section
and remove the grease filters and carbon filters.
When fixing the hood to the ceiling allow the electric cable to pass through into the
hood (not supplied). Fix the hood to the ceiling using the four screws provided.
Make the electrical connection in to the metal box (fig.18). The power supply metal
box is postioned close to the electrical componets and you can see them after
removing the grease filters.
Please connect the cable as shown in fig. 18. Once done refit the carbon filters and
grease filters, the close the glass panels.
CE1122SS/WH_Instruction manual.indd 9 22/03/2018 10:53
To Next Page
Loading...
