10 EN
3-3 Video Recording Mode
3-4 Playback Mode
By default, the system will automatically begin continuous recording a few sec-
onds after start-up. The icon on the upper left corner of the screen will flash.
The LED light indicator besides the power button should flash red, indicating that
recording is in progress. You can manually stop the recording by pressing this
icon . Pressing it again will restart recording. The recorded video will be saved
under the “DCIM” folder on your Dash Cam’s TF memory card.
• In Recording mode, you can take photos by pressing this icon .
• You can also enable or disable voice recording by pressing this icon
on
the bottom right corner of the screen.
• You can lock/unlock a recorded file by pressing this icon .
• When the memory card is full, new videos will record over the oldest videos.
3-3-1 Continuous Recording
Notes
You can press this icon on the Dash Cam to begin manual recording.
Press this icon again to stop manual recording.
3-3-2 Manual Recording
1. When in Recording mode, press this icon to shift to Playback mode.
2. Press / to select your desired video clip or photo, and press it to start
playback. You can also delete it by pressing this icon . A dialog box will ask to
delete the current file or all. Make sure the file is unlocked before you delete it.
3. Press this icon to lock/unlock your file. The file will be labeled with this
icon When you lock a file, it is protected and cannot be replaced by new files
until you delete the file or reformat the memory card.
4. Press the back icon to exit playback mode.
To Next Page
Loading...
