2-2 Mounting your Dash Cam
Method 1: Mounting your Dash Cam with suction cup.
1. Angle the mount so that it can slide into the magnetic
slot on top of the camera. Align the magnets of the
mount with the camera’s magnetic contacts and slide
it into place. Then remove the protective film from the
camera lens and the protective film from the suction
cup.
You can mount the Dash Cam with either of these methods:
2. Getting started
2-1 Inserting a memory card
Class 10 or higher TF memory card with a storage capacity of 8GB - 256GB must be
used.
1. As shown in the illustration, hold the edge of the card, and insert it into the slot, with
the metal contacts facing up. Push until you hear a click.
To remove the TF memory card, gently push on the edge of the card in until it clicks
out from the slot, then pull out the card.
Note: Make sure the contacts of the
TF memory card are facing the same
direction as the display.
Inserting a TF card
Do not apply excessive force to the card or attempt to insert it in the
wrong direction. This may cause damage to the card and the card slot.
Note
5 EN
To Next Page
Loading...
