PD200
Unpacking
Remove the scale from the carton by grasping the column (not the display) and lifting up with
equal force on the column and the scale base. After removing from the carton, check for any
damage that may have taken place during shipment. Keep and use the original carton and
packing material for return shipment if it should become necessary. The purchaser is
responsible for filing all claims for any damages or loss incurred during transit. Remove all
plastic wrapping, foam fillers and cardboard material from the scale.
Assembly
The PD200 does not require any assembly.
After installing batteries, the scale is ready for
operation.
Quick Start
Although it is recommended that you read this manual before attempting to operate the scale,
this section is included to provide a condensed set of instructions on installing and using the
scale. At a minimum, please make certain you read all of the caution and warning statements.
Step 1. Place the scale on the floor.
Step 2. Carefully turn the scale over with the display resting on the floor and then locate the
battery access cover on the bottom of the scale.
Step 3. Remove the cover, install six (6) “AA” size batteries
1
and then replace the cover.
Step 4. Turn the scale over to the normal operating position and make sure it is level.
Step 5. Press the ON/OFF key to turn the scale on.
2
Step 6. When the display is showing 0.0, have to patient step on the scale.
Step 7. Wait a few seconds for the weight to display and then read the patient’s weight.
Step 8. Patient may now step off scale.
Step 9. Press the ON/OFF key to turn the scale off.
1
See page 16 for detailed instructions on installing the batteries.
2
For complete Operation and Setup instructions, refer to pages 18 to 26
0044-M340-O1 Rev C ProDoc Series
7
To Next Page
Loading...
Need help?
General