OPERATION
Storing Weight with the STORE Key
1. With patient on scale and display showing patient’s weight, press STORE key.
2. The MEM 1 position annunciator will flash.
(Position 1 Selected)
3. Press the STORE key until the desired MEM position is selected. The MEM position
annunciators (1, 2, 3 or 4) will flash to show which position is currently selected.
NOTE! Repeatedly pressing the STORE key will advance to the next MEM position and
return to the MEM 1 position.
(Position 2 Selected)
4. When the desired MEM position has been selected, press the BMI HEIGHT/ENTER key to
store the weight.
5. Once the key has been pressed, the software will capture the weight in this location. As
soon as there is no motion and weight is stable, the MEM position annunciator will stop
flashing and remain on to show a stable weight has been stored.
(Weight Stored in Position 1)
6. Patient may now step off scale.
7. Once the patient steps off scale, the display automatically returns to weight only mode.
Any previously turned on MEM position annunciators will turn off.
0044-M340-O1 Rev C ProDoc Series
24
To Next Page
Loading...
Need help?
General