OPERATION
Keypad Functions, Cont.
The
BMI HEIGHT/ENTER key is used to perform several functions during normal
operations. Note that the scale will not respond to pressing the key unless the
weight is stable.
If the scale has the Digital Height Rod installed, pressing the key once will display the
height data from the height rod. Once the height rod is adjusted to the patient, pressing it
again will display the Body Mass Index (BMI) calculation. Pressing it a third time, will
return the display to the patient’s weight.
With a mechanical height rod or no height rod, pressing the key once allows the operator
to enter the height of the patient using the RECALL or STORE keys to increment or
decrement to the correct height. After entering the patient’s height, pressing it again will
display the Body Mass Index (BMI) calculation. Pressing it a third time, will return the
display to the patient’s weight.
In the Memory Function operation, pressing the BMI HEIGHT/ENTER key will signal the
software that the desired MEM position has been selected and to store the current weight
in that location.
The RECALL or STORE keys are used when performing the Body Mass
Index (BMI) calculation to increase or decrease the height value.
In the Memory Function operation, pressing the STORE key will select the
MEM position (1 through 4) to store the current weight on the scale. Repea
pressing the key, will advance to the next memory location and return to the first.
tedly
Pressing the RECALL key will select the MEM position (1 through 4) and
display the weight stored in that location. Repeatedly pressing the key, will step
through each memory location and return to displaying the current weight.
0044-M340-O1 Rev C ProDoc Series
19
To Next Page
Loading...
Need help?
General