Cardo Systems G9 User Manual

CONTENTS OF RETAIL BOX
NOTE: If you purchased the scala rider G9 PowerSet, your Retail
Box will include two sets of each component listed below.
G9 Audio Kit
Interchangeable
exible boom
(Corded mic also
provided)
Sliding
Panel
Two
speakers
MP3 Jack
(back)
Noise canceling
sealed omni
microphone
scala rider G9 Unit
Channel A Button
• Connect to Rider A
• MP3 Button
Channel B Button
• Connect to Rider B
• FM Radio Button
Voice Command
Button
“One+8” Intercom
• Charging
jack
• Software
download
port
Silicone Cover
Volume Down / Rewind button
Flip-up Antenna
Mobile phone button
Volume Up / Forward button
IMPORTANT:
The scala rider G9 has been certied as waterproof and dustproof (IP67).
However, when in use, the silicon cover of the Charging Jack should
be kept tightly closed to prevent moisture from entering the unit.
Corded Microphone
Replacement Mic sponges*
Allen wrench
Wall charger plug
Pre-moistened Towlettes
Alcohol
Pad
USB adapter cable
MP3 cable
Velcro Pads
Carry pouch
Glue plate
* The large microphone sponge is recommended for use with open helmets
2. CHARGING THE SCAlA RIDER G9
Make sure that your scala rider G9 is fully charged for at least
4 hours before initial use.
1. Open the silicone cover protecting the Charging Jack.
2. Insert the USB cable into the Charging Jack.
3. Insert the other end of the USB cable into the wall charger or a
computer’s USB port.
4. While charging, the red LED turns on. When charging is
complete, the red LED will turn o.
4 | scala rider
®
G9 / G9 PowerSet 4 | scala rider
®
G9 / G9 PowerSet

Cardo Systems G9 Specifications

General

Brand	Cardo Systems
Model	G9
Category	Headsets
Language	English