2.3 SWITCHING YOUR UNIT ON/OFF
To switch your PACKTALK BOLDon:
● Press both and for 1 second.
The speaker plays an ascending tone and a voice message greets you.
The LED confirms your PACKTALK BOLD is on:
● Normal and low battery — LED flashes blue three times, then green.
● Charging — LED flashes red and purple three times.
To switch your PACKTALK BOLDoff:
● Press both and .
The LED flashes red three times, confirming that your unit is switching off. The speaker plays a
descending tone and a voice message, "Goodbye".
2.4 USING YOUR PACKTALK BOLD
You can operate the various features of your PACKTALKBOLD in the following ways;:
● Press a button or combination of buttons on the unit.
● Use the Cardo Mobile App on your mobile device (once it is paired with the unit).
● Use automatic voice recognition (by saying a command, for example "Hey Cardo, Radio On").
You can also configure your unit by connecting it to a computer with the supplied USBcable and running the
Cardo Updater while your computer is connected to the Cardo Update website.
2.5 PAIRING YOUR UNIT TO BLUETOOTH DEVICES
Your PACKTALK BOLD has two Bluetooth channels for connection to Bluetooth devices such as mobile
phones, GPS devices, and Bluetooth music players with A2DP.
To connect your unit to a Bluetooth device, you must first pair them. Once paired, they automatically recognize
each other whenever they are within range.
If you are pairing more than one device, Cardo recommends that you pair the mobile phone to channel 1,
and the additional device (such as GPS, music player or additional mobile phone) to channel 2.
If you are pairing the unit to more than one mobile phone, the phone paired with channel 1 is the default
phone for outgoing calls.
To pair Bluetooth channel 1 to a mobile phone:
1. Enable Bluetooth on the mobile phone.
2. On the unit in standby mode, press for 5 seconds.
The LED flashes red and blue.
3. On your mobile phone, search for Bluetooth devices.
6
To Next Page
Loading...
Need help?
General
