4.2 BLUETOOTH INTERCOM
To connect your unit to another unit with a Bluetooth intercom, such as a Cardo Bluetooth unit or other
Bluetooth-enabled devices, you must first pair their channels. Once paired, the units automatically recognize
each other whenever they are in range (line of sight up to 1.6 km / 5,200 ft subject to terrain).
● Pairing a channel replaces any existing paired unit on that channel with the new unit.
● If you purchased the PACKTALK BOLD DUO, the retail package contains two pre-paired units in DMC
mode.
● The Intercom range with other models is limited to the distance of the unit with the shorter range.
4.2.1 SETTING UP NON-DMC INTERCOM GROUPS
DMC is always the best way to connect a group of riders. If you happen to ride with a group of riders that do not
have DMC devices (such as Bluetooth communicators by Cardo or by other brands), you can switch your unit
to Bluetooth mode and create or join a non-DMC group. The participating riders are connected in a chain with a
maximum total of four riders.
To set up a Cardo non-DMC group:
1. Confirm your unit is in Standby Bluetooth intercom mode (LED flashes blue slowly).
If your unit is not in Bluetooth intercom mode, tap and . For more information see, Switching
between Intercom modes on page 20.
2. To initiate 2-way pairing:
● On your unit, press for 5 seconds to enter pairing mode.
The LED flashes red.
● The following announcement is heard: Rider A pairing.
Bluetooth intercom pairing needs to be initiated on the other device.
The unit confirms that pairing has succeeded.
3. To add a 3rd rider:
● Press for 5 seconds. The LED flashes red.
● Tap 2 times. The LEDflashes blue.
The following announcement is heard: Rider B pairing.
16
To Next Page
Loading...
Need help?
General
