5.2a “1+8” INTERCOM TOGGLING
with PACKTALK / SMARTPACK, G9 / G9X, cardo SHO1 and SRCS PRO
Pair with up to 8 other devices (“1+8” Buddies) and connect with them one at a time
by saying their name.
CONFIGURE YOUR BUDDY NAME
Before using “1+8” Intercom, you should assign yourself a Buddy name, so that other
paired Buddies can call you by this name. Visit the Cardo Community to congure your
Buddy Name (see Section 3).
Until you congure a Buddy name, your unit will be known as “PACKTALK”.
If you change your Buddy name, you must pair again with your “1+8” Buddies for their
devices to receive the new name.
Hear Your
Buddy Name
In Standby, press
Z
and
v
simultaneously for 2 seconds. You will hear your
Buddy name through the speakers.
Check Your
Buddy List
Check via the Cardo SmartSet and Cardo Community. You can also hear your
Buddy List through the speakers: In Standby, press
Z
for 2 seconds
PAIRING “1+8” BUDDIES
There are three ways to pair with “1+8” Buddies:
OPTION 1: Via the Cardo Community® (ALL models)
g
OPTION 2: Via the Cardo SmartSet App (PACKTALK/SMARTPACK models)
☛
OPTION 3: Manual “1+8” Pairing (PACKTALK/SMARTPACK models)
1. In Standby, press
Z
for 5 seconds to enter “1+8” Pairing mode.
2. Enter “1+8” Pairing mode on the second unit.
3. A purple LED for 2 seconds indicates pairing was successful.
If your scala rider already has a full list of 8 paired “1+8” Buddies, pairing another
buddy will replace the buddy that you have not spoken to for the longest time.
18
|