Cardo Systems SCALA RIDER TEAMSET PRO User Manual

3. Pick up one headset and simultaneously press and hold the CTRL
Button and Intercom Button for at least six seconds until the Red
Light begins ashing rapidly, indicating it is in Intercom Pairing mode.
4. Repeat Step 3 again for the second scala rider TeamSet pro
headset. Both headsets should now be ashing rapidly in Red.
5. Within a few seconds, both headsets will show a solid Red light
for two seconds, and then begin ashing slowly in Blue.
If the Pairing process is not completed within one
minute the headset will return to Standby mode.

If you have a Bluetooth enabled mobile phone and would like to
make and receive phone calls using the scala rider TeamSet pro ,
you must rst pair your headset to the mobile phone.
 If you have a compatible Bluetooth GPS device you wish to
use with the scala rider TeamSet pro , please skip this step, and
continue ahead to BLUETOOTH
Pairing is a one time process. Once the headset is paired to a specic
mobile phone during this Setup Procedure, they will remain paired
and automatically recognize each other whenever they are within
range. If the connection between the phone and headset is lost, tap
the CTRL button to reconnect the devices.
To pair the scala rider TeamSet pro to a Bluetooth phone proceed as
follows:
1. Turn on your phone and make sure its Bluetooth function is
activated.
2. With the scala rider TeamSet pro headset turned ON, press
and hold the CTRL Button for at least six seconds until the Red
and Blue Lights begin rapidly alternating.
3. Search for Bluetooth devices on your phone by following the
phone’s instructions. Please consult your phone’s User Manual
for more information.
4. After a few seconds the phone will list the “scala rider
 as a discovered device. Select it and follow your
phone’s instructions to accept the pairing.
5. When prompted enter 0000 (four zeros) as your PIN or passkey.
6. Your phone will conrm that pairing has succeeded and the
headset will begin ashing slowly in Blue.
If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
With some mobile phones, you may need to tap the CTRL button
to connect the headset to the phone after pairing is complete. The
scala rider TeamSet pro headset will automatically connect to the
last phone connected to the headset.
BLUETOOTH
If you have a Bluetooth enabled GPS device and would like to transmit
navigation instructions and sounds from the GPS device through the
headset’s speakers, you must rst pair your headset to the GPS device.
NOTE: Not all Bluetooth enabled GPS devices allow connections to
Bluetooth headsets like the scala rider TeamSet pro . Please consult
your GPS device’s User Manual for more information.
To pair the scala rider TeamSet pro to a Bluetooth GPS device
proceed as follows
1. Turn on your GPS device. Make sure Blutetooth mode is activated.
2. With the scala rider TeamSet pro headset turned ON, press
and hold the CTRL Button for at least six seconds until the Red
and Blue Lights begin rapidly alternating.
3. Search for Bluetooth headsets on your GPS device by following
the device’s instructions. Please consult your GPS device’s User
Manual for more information.
English
5
scala rider
®
TeamSet
™
PRO

Cardo Systems SCALA RIDER TEAMSET PRO Specifications

General

Brand	Cardo Systems
Model	SCALA RIDER TEAMSET PRO
Category	Headsets
Language	English