23
Check point Inspection Ref. What to do if the inspection is failed
Seat /
Upholstery
Check for movement and if
it’s worn.
P.11 Contact your dealer.
Electronics
Check if all the battery cables
and connectors are rmly
tighten to the scooter
P.13 Contact your dealer.
7.3 MONTHLY CHECK
7.CARE AND MAINTENANCE
7.4 CLEANING YOUR SCOOTER
» Do not use any abrasive or scouring liquids for cleaning. Only use a damp cloth and gentle
detergent.
» Do not use hose pipe or splash water directly onto the scooter as this may cause damage to
electronics.
7.5 MAINTENANCE
» User should inspect the scooter regularly to keep scooter in good running order.
» Check if the electrical cable connectors are fully connected.
» All maintenance and repair of scooter should be done by an authorized dealer.
Seat Upholstery:
Only use damp cloth and a little soap to wipe the seat. Do not use abrasive cleaners as this will
damage the seat.
Frame / Shroud:
» The frame and shroud of the scooter can be wiped with lightly damp cloth. Do not use
abrasive cleaners as this will damage the coating.
» Car polish can be used to keep the paint and frame in pristine condition.
Storage:
» Please store the scooter in a dry location. If store the scooter in long time, please disconnect
the battery terminals.
» Do not store your scooter where it will be exposed to source of direct heat, damp, oil, acid,
alkaline, or where Ozone could be possibly generated. All of the above will minimize scooter /
tyre cycle and shorten its lifetime.
Tyre:
User should inspect the tyres frequently for damage, the presence of foreign bodies, unusual wear
and sucient tread depth. If replacement tyres are needed, please contact the nearest dealer.
The following areas require periodic inspection:
» Tyre pressure between 30-35 psi
» Tread depth drops below 0.5 mm
Recommended range of storage:
Temperature : -30oc ~ +50oc, Humidity : 25% ~ 85%
To Next Page
Loading...
