What should I do if my Carel GDWRI20A00 unit displays a system flash memory write error?
A system flash memory write error on your Carel Gas Detectors device indicates an error writing to the internal flash memory. Try power cycling the device. If the error continues, contact service.
What should I do if my Carel GDWRI20A00 unit displays a system flash memory read error?
A system flash memory read error on your Carel Gas Detectors device indicates an issue while reading the internal flash memory. Try power cycling the device. If the error continues, contact service.
General| Model | GDWRI20A00 |
|---|---|
| Gas Type | Refrigerant gases |
| Operating Temperature | -20°C to +50°C |
| Output Signal | 4-20 mA |
| Power Supply | 24 V AC/DC |
| Refrigerant Compatibility | R32, R410A, R134a, R404A, R407C |
| Type | Infrared Gas Detector |
Key warnings and instructions for safe handling and operation of the gas leakage detector.
Describes the features, specifications, and components of the built-in version.
Details the specifications, components, and features of the remote version of the detector.
Covers power supply, signal wiring, remote head connection, and Modbus interface setup.
Details the Home tab, calibration/bump test access, and configuration options for alarms and Modbus.
Mandatory steps for ensuring sensor accuracy, including zero and full-scale calibration.
Identifies fault codes, their causes, and recommended corrective actions for device issues.
Details electrical inputs, outputs, power requirements, and wiring standards for the detector.
Covers operating life, calibration needs, alarm set points, response times, and temperature compensation.
To Next Page
