Carestream DRX-Revolution - Power Button Operation

Operating the System
AF0118 | 2018-03-27 4-3
Power Button Operation
The system uses a “soft-off” style power button, which may operate differently than
other Carestream products. Pressing the power button to shut down the system will
put the system into a standby, low-power consumption state. Mains battery charging
and brake release using the buttons on the handles remain available in standby.
Put the
system into
standby
mode using
the power
button
When the system is ON, press and release the power button to put the system into
standby mode.
Note
This will disable detector battery charging.
Start up the
system using
the power
button
When the system is OFF, press and release the power button to start up the system.
Re-boot the
system using
the power
button
When the system is ON, press and hold the power button down for at least four
seconds.
Note
Before performing the system reboot using the power button, attempt to reboot the system
using the Quick Menu in DirectView.