Carestream DRX-Revolution - Troubleshooting; System Startup Issues; Startup Task Failures; Console Blocking Errors

AF0118 | 2018-03-27 7-1
7 Troubleshooting
Problem
Recommended Action
The system does not start
up.
• Check the battery level indicators.
• Make sure all applicable switches on the system are on.
• If the problem persists, contact your authorized Service
Provider.
During startup, one of the
tasks in the Startup screen
does not start.
• Power down the system and power up the system again.
• If the failure occurs again, contact your authorized Service
Provider.
The Operator Console
powers up successfully, but
reports a blocking error.
• Power down the system and power up the system again.
• If the blocking error occurs again, contact your authorized
Service Provider.
The Operator Console
powers up
successfully, but
the application does not
start.
• Power down the system and power up the system again.
• If the problem persists, contact your authorized Service
Provider.
You cannot log on.
• Make sure you are using the correct login and password. Note
that passwords are case-sensitive.
• Check with your System Administrator or Key Operator.
•
If the problem persists, contact your authorized Service Provider.
Unable to set parameters
due to a failed
communications link
• Power down the system and power up the system again.
• If problem persists, contact your authorized Service Provider.
Faulty tape measure
Contact your authorized service provider.
Issues with the exposure
switch
Contact your authorized service provider.
The arm will not hold
position and sags out of
position.
If the problem persists, contact your authorized service provider.
Batteries fail to charge
• Power down the system and power up the system again.
• If problem persists, contact your authorized Service Provider.