Carlson Boretrak2 - Page 47

BT2 user manual - H-5911-9004-02-B Page | 47
• 2 x Rubber wheels
• 2 x M6 x 40 mm screw with nut and washer
• 4 x M6 x 35 mm screw with washer
• 2 x M8 x 45 mm screw with nut and washer
The tools required for assembly are:
• 6 mm hex key
• 5 mm hex key
6.8.2 Assembly
Thread the brake handle onto the hub of the drum axle.
Hold the wheel axle against the push rod frame and align the holes in the axle with the holes in the frame.
Brake handle
Drum axle
Figure 52 Assembling the push rod system - step 1
Wheel axle
Push rod frame
Figure 53 Assembling the push rod system - step 2