To Next PageTo Next PageWhy Carlton SP5014TRX head swings faster one way than the other?
If the Carlton Cutter head swings faster in one direction than the other, the counter balance valve is likely out of adjustment. Adjust the counter balance valve to equalize the swing speed.
Why Carlton Cutter swing cylinder loss of power?
The Carlton Cutter swing cylinder might lose power if the cutter head speed adjustment screw is turned wide open. To slow the cutter head swing at high RPM, turn the valve counter-clockwise.
Why Carlton SP5014TRX Cutter bearing will not take grease?
If the Carlton Cutter bearing won't take grease, it's likely because the grease fitting is clogged. Replace the fitting.
Essential safety gear and attire for operation.
Rules for safe machine operation, fuel handling, and battery safety.
Operation of engine, hydraulic levers, and steering.
Setup, programming, and operation of the remote control system.
Steps for starting the machine and performing stump grinding.
Routine checks, engine oil, and filter replacement procedures.
Schedule for greasing and lubricating machine components.
How to arrange and replace cutter teeth for optimal performance.
Process for sharpening cutter teeth.
Maintenance of hydraulic oil, filters, and pump replacement.
Electrical schematics for standard and remote control systems.
General