16 EN
2. Clean the automatic milk froth system (see “Cleaning and
Maintenance”).
3. Fill the milk container with milk and close the lid. Use cold
semi-skimmed or full-fat 3.2-4 % milk (at a temperature of
approximately 5 °C) with a protein content of at least 3-3.5 %
to ensure an optimal frothing result.
4. Switch the appliance on by pressing the power on/off button
. Make sure that the drip tray is under the coffee spout and
that the water tank is not empty. The appliance will perform
auto-rinsing, you can stop it by pressing . The appliance will
enter the standby mode.
5. Place a cup under the spout. Press Latte Macchiato button
, the indicator light will be on while the appliance is
preparing coffee. The machine will dispense milk first and then
coffee. To stop preparation, press again.
6. When the coffee is ready to serve, the appliance will be back
to the standby mode.
7. Remove the milk container from the appliance and put it in the
fridge.
8. After use see “Cleaning the automatic milk froth system”.
CAUTION!
Steam and hot milk may spray out of the spout at the
beginning of the brewing.
Place the connection milk tube around the milk
container lid after use. Do not let it fall freely to
prevent milk spray out because of the pressure drop.
To Next Page
Loading...
