EN 25
3. Connect the milk container to the coffee machine (see
“Preparing Latte Macchiato”).
4. Press the Cleaning button twice. The appliance will
dispense hot water and steam to wash the dispensing tube and
milk spout.
5. Touch again to stop the water.
6. Take the spout cover off and then take the milk frother out.
7. Take the milk frother apart into two parts and clean under
running water. You can use the brush to clean the circle area to
ensure there is no residual left.
8. Assemble the milk frother back and install it into the appliance.
CLEANING THE MILK CONTAINER AND CONNECTION MILK
TUBE
NOTE:
It is important to do this step daily to make sure the automatic
milk frother works as it should.
1. Empty the milk container and wash it under running water,
then take the connection rubber and container milk tube out to
wash them under running water. Then, assemble them to the
lid again (make sure they are installed properly).
2. Clean both ends of the milk connection tube under running
water and make sure the holes on the milk tube connectors are
To Next Page
Loading...
