18 EN
approximately 5 °C) with a protein content of at least 3-3.5 %
to ensure an optimal frothing result.
3. Switch the appliance on by pressing the power on/off button
. The appliance will perform auto-rinsing, you can stop it by
pressing . The appliance will go into the standby mode.
4. Place a cup under the spout and press the button twice; the
indicator light will be on. To stop preparation, press again.
5. When the milk foam is ready to serve, the appliance will be
back to the standby mode.
6. Remove the milk container from the appliance and put it in the
fridge.
7. After use see “Cleaning the automatic milk froth system”.
PREPARING HOT WATER
1. Put a cup under the spout.
2. Press Hot water button ; the indicator light will be on. The
appliance will start dispensing hot water. To stop the water
flow, press again.
08. ADDITIONAL SETTINGS
ADJUSTING COFFEE/HOT WATER QUANTITY
The appliance can memorize your desired volume of coffee and
hot water.
1. Place a cup under the spout.
2. Switch on the appliance, all button lights will be on. Press
Espresso/Cappuccino/Latte Macchiato/Hot Water button. The
indicator light will be on.
3. When the appliance starts dispensing coffee/water, touch and
hold the button until you get the quantity needed. The MAX
quantity is 250 ml. You will hear two beep sounds meaning
that the new quantity is memorized by the appliance.
To Next Page
Loading...