Carrera 657 - Page 28

28 EN
No milk foam.
The automatic milk
frother is dirty or is
not assembled or
installed correctly.
The hole of the milk
tube connector is
blocked by milk
residues.
Clean the automatic
milk frother and
make sure it is
correctly assembled
and installed.
Clean the connector
and make sure that
all holes of the
connector are clean,
use the needle or
the bristle of brush
to clean the holes.
The holes of the
milk tube connector
are blocked by milk
residues that are
hard to clean.
The milk tube
connector has not
not been cleaned
for a long time.
Soak the milk tube
connector in warm
water for an hour,
then clean it. Keep
using frothing milk
function until water
comes from the
dispenser smoothly.
Use the needle or
the brush to clean
the holes.
The type of milk
used is not suitable
for frothing.
Forth quantity and
quality depends on
the milk type. Use
semi-skimmed or
full-fat cow’s milk for
good results.
The milk used is too
warm.
Cool the milk in the
fridge before using.
Milk sprays out on
the table.
The milk dispensing
tube is not put in
place.
Install the milk
dispensing tube
properly.