AppController overview and specifications
AppController CARRIER CORPORATION ©2019
Installation and Start-up Guide All rights reserved
3
Built-in surge and transient protection for power and communications in
compliance with EN61000-6-1.
Incoming power and network connections are protected by non-replaceable
internal solid-state polyswitches that reset themselves when the condition that
causes a fault returns to normal.
The power, network, input, and output connections are also protected against
transient excess voltage/surge events lasting no more than 10 msec.
CAUTION To protect against large electrical surges on serial EIA-485
networks, place a PROT485 at each place wire enters or exits the building.
LEDs indicate status of communications, running, errors, and power.
Environmental operating
range
0 to 130°F (-18 to 54°C), 0 to 90% relative humidity, non-condensing
Storage temperature range
-24 to 140°F (-30 to 60°C), 0 to 90% relative humidity, non-condensing
Rugged GE C2950HF Cycoloy plastic
5-5/8 in. (14.3 cm)
5-1/8 in. (13 cm)
5-1/4 in. (13.3 cm)
2-9/16 in. (6.5 cm)
3/16 in. (.5 cm)
Conforms to the BACnet Advanced Application Controller (B-AAC) Standard Device
Profile as defined in ANSI/ASHRAE Standard 135-2012 (BACnet) Annex L,
Protocol Revision 9
UL-916 (PAZX), cUL-916 (PAZX7), FCC Part 15-Subpart B-Class A, CE
Safety considerations
WARNING Disconnect electrical power to the AppController before wiring it. Failure to follow this warning
could cause electrical shock, personal injury, or damage to the controller.
To Next Page
Loading...
Need help?
General
