Carrier AQUASNAP 30RB series - Menu Tree Structure

90
MENU TREE STRUCTURE
MENU
Legend * Displayed if the configuration requires it ** Displayed if the alarm exists - Not in use
1 For heat pump units 2 For cooling only units
PRESSURES Discharge pressure circuit A Suction pressure circuit A Discharge pressure circuit B* Suction pressure circuit B* Discharge pressure circuit C* Suction pressure circuit C* Vacuum pressure, circuit A* Vacuum pressure, circuit B* - - - - - - - - - - - -
SETPOINTS Cooling setpoint 1 Cooling setpoint 2 Ice storage setpoint* Heating setpoint 1* Heating setpoint 2* Auto changeover threshold (cooling mode)* Auto changeover threshold (heating mode)* Heat reclaim mode input setpoint* Heat reclaim mode input dead band* Setpoint demand limitation 1* Setpoint demand limitation 2* Setpoint demand limitation 3* Ramp loading* Cooling - zero reset threshold* Cooling - full reset threshold* Cooling - full reset value* Heating - zero reset threshold* Heating - full reset threshold* Heating - full reset value*
INPUTS Contact 1: on/off/ heating/cooling Contact 2: setpoint selection Contact 4: heating/ cooling[1]* Contact 4: heat reclaim [2]* User safety loop input status Water pump operation contact status* Control box thermostat Contact 3: demand limit selection 1* Contact 3 bis: demand limit selection 2* Ice storage remote contact* Remote unit contact, continued occupied mode* User safety loop input* Demand limit control limitation value* Setpoint reset value* Ambient temperature value* Subcooling liquid temperature, circuit A* Subcooling liquid temperature, circuit B* Subcooling tempera- ture, circuit A* Subcooling tempera- ture, circuit B*
OUTPUTS Output 1 Output 2
CONFIG SUB-MENU: User
Configuration (USEr) SUB-MENU: Service Configuration (SErviCE) SUB-MENU: Factory Configuration (FACtorY) - - - - - - - - - - - - - - - - -
ALARMS Number of active alarms/ resets** Active alarm code 1** Active alarm code 2** Active alarm code 3** Active alarm code 4** Active alarm code 5** - - - - - - - - - - - - - -
ALARMS HIST Historic alarm code 1** Historic alarm code 2** Historic alarm
code 3**
Historic alarm code 4** Historic alarm code 5** Historic alarm code 6** Historic alarm code 7** Historic alarm code 8** Historic alarm code 9** Historic alarm code 10** Historic alarm code 11** Historic alarm code 12** Historic alarm code 13** Historic alarm code 14** Historic alarm code 15** Historic alarm code 16** Historic alarm code 17** Historic alarm code 18** Historic alarm code 19** Historic alarm code 20**
RUNTIMES SUB-MENU: Runtimes 1 SUB-MENU: Runtimes 2 SUB-MENU: Runtimes 3 SUB-MENU: Maintenance - - - - - - - - - - - - - - - -
ITEM
0 1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17 18 19
STATUS Default display Mode Chiller occupied mode* Minutes left Cooling/heating selection* Cooling/heating status* Heat reclaim selection* Total capacity in % Capacity circuit A in % Capacity circuit B in % Capacity circuit C in %* Present demand limit in % Present lag limit in %* Setpoint in local control Setpoint occupied mode Active setpoint Control point Controlled water temperature Indicator, heat recovery in progress, circuit A* Indicator, heat recovery in progress, circuit B*
TEMP Evaporator water entering temp. Evaporator water leaving temp. Outdoor temperature Heat reclaim entering water temp.* Heat reclaim leaving water temp.* Saturated discharge temperature circuit A Saturated suction temp. circuit A Suction temperature, circuit A Superheat, circuit A Saturated discharge temp. circuit B Saturated discharge temp. circuit B Suction temperature, circuit B Superheat, circuit B Saturated discharge temp. circuit C* Saturated discharge temp. circuit C* Suction temperature, circuit C* Superheat, circuit C* Defrost temperature, circuit A* Defrost temperature, circuit B* System water temperature*