Carrier CDII-184R1-0CTR4 - Page 41

41
9.3.1 Corded Remote’s Indication and Buttons Description
Sr.No
Indication
Function
1
Mode
For Indication of Machine’s Mode.
2
Auto Fan Speed
For Indication of Auto Fan Speed.
3
Fan Speed
For Indication of Fan Speed.
4
Temperature
For Indication of Temp.
5
Temperature Unit
For Indication of Temp. Unit.
6
Fan
For Indication of Fan Speed.
Sr.No
Buttons
Function
7
Mode
For Selection of Machine’s Mode.
8
Fan Speed
For Selection of Fan Speed.
9
Temperature Down
For Setting of Temperature Down.
10
Temperature Up
For Selection of Temp. Up.
11
Power On/Off
For Power On/Off the Machine.
Table.1
9.4 Indoor Unit Operation by “Corded Remote”
1. POWER ON/OFF
Switch On “Main Power supply”, Press button to turn ON/OFF the Air Conditioner.
When turn ON, it will operate according to the setting shown on the Display unit.
2. “Mode Selection” changes are done by Button to Fan and Cool mode.
▪ FAN: The System will operate as the fan only .In this mode, the temperature setting and Sleep
Function will not operate.
▪ COOL: The System will operate as the cooling unit.
The Compressor will
• Increase Capacity if Troom > Tset.
• Decrease capacity if Troom < Tset.
• Stop if Troom < Tset-1.5.
However, the compressor is subjected to 6-minutes delay protection each time it stops.
▪ DRY: The System will operate as the Humidifier.
*Note: In Dry mode, Fan Button will not operate.
3. “Temperature Settings” (Increase and Decrease) are done by “ ” & “ ” Button.
Press Temp “ ”down or Temp up “ ” button to set the temperature in a range of 18 to 32
deg C.