OM-KSACN1401AAA-01 Specifications subject to change without notice. 19
Intelligent eye display
1. This function is valid in any mode of power-on state.
2. When the indoor unit sending wire controller has the smart eye function, press the
function key to select the smart eye icon, press the OK key to turn on the smart eye, and
light up the smart eye icon at the same time; when the smart eye is turned off, the smart
eye icon goes out.
3. Shutdown, switch mode, turn on self-cleaning, turning on 46°F (8°C) heating function
automatically cancels the smart eye function.
NOTE: Intelligent Eye Display is only available in High Tier and Mid- Tier models.
Filter reset function
After the indoor unit sends the wire controller filter usage time, the filter cleaning prompt
icon lights up, press the function key to select the filter cleaning prompt icon, and press the
OK key to reset the filter screen time. The filter cleaning reminder icon goes out.
Humidity setting function:
1. When the indoor unit sending wire controller has dual control function of temperature
and humidity, in dehumidification mode, press the function key to select the RH icon,
press the confirm key to enter the humidity control mode, the RH icon flashes, press the
up and down keys to adjust the humidity. The setting range is OFF->35%~85%,
adjusted with 5% humidity. Exit humidity adjustment state after 5 seconds of inactivity.
2. After entering the humidity control mode, press the up and down keys to adjust the set
temperature and display the set temperature for 5 seconds, and then restore the set
humidity display.
3. After switching the mode, exit the humidity control mode.
To Next Page
Loading...
