UNIT OPERATION
The air discharge direction can be controlled to swing up and down and can be fixed at a preferred position or at automatic position by the remote control.
• If you select the flap position using the FLAP button in the remote control, the flap in the unit
will move to that position automatically.
Once you select the position, the unit remembers that position and whenever you turn on
the unit, the flap will be positioned to that position.
• If you select SWING, the flap will swing up and down. In the COOL, DRY and FAN mode,
the flap will swing in the cool range. In the HEAT mode, the flap will swing in the heat range.
• If you select AUTO, the flap will position itself to the preset position according to the operation mode.
CLOSE
Remote Control Auto Position
Swing Range
If you want to adjust the direction of the discharge air left or right, adjust the vertical louver with
the handle after opening the flap.
COOL
HEAT
COOL
HEAT
• Always use the remote control to adjust the flap position,
otherwise it may cause abnormal operation.
Please turn off the unit and turn it on again when you
manually adjust the flap out of range.
NOTE
DISCHARGE AIR LOUVER CONTROL
Up and Down Control
14
Left and Right Control
• Please do not fix the flap at position 햷 for a long time, because this position minimizes air circulation resulting in uneven room temperature.
• Do not adjust the flap by the hand during SWING operation because it may damage the air swing mechanism.
• If you want maximum cooling or heating capacity, please set flap at position 햴.
NOTE
HANDLE
AUTO
SWING
To Next Page
Loading...
