Carrier p3 series - Wiring, Power, Testing, and Special Operations

After connecting the pipe, check the joints for gas leakage with gas leak detector or soapy water.
29
• Wrap the piping joints with the pipe insulation and fasten it with vinyl tape. ( Figure. 17, 18)
• Fill the gap between the inside of wall sleeve and the pipe with a sealer so that rain and wind does not enter. ( Figure. 19 )
Figure 17
Pipe
Pipe insulation
(Vinyl tape)
Figure 19
Wall sleeve
Wall cap
Sealer(Putty)
Indoor side Outdoor side
Figure 18
Pipe
Saddle
GAS LEAK CHECK
FINISHING
Wall