PROGRAMMING THE THERMOSTAT
Setting the away temperature
1. Press the away button located under the display in the cen- o[_lo
I I I I
ter. You will see a triangle icon (V) above the away but-o[I ito
ton. o_o
2. You will see the heating and cooling temperatures that ooo o
were set at the factory. To use these, just close the door.
3. To change the factory settings, press the away button. You o_e
will see the word heat flashing on the screen, o_e
4. Press the up or down button on the right side of the dis- o o
play until you reach the correct temperature setting, o o o o
5. Press and hold the away button for about three seconds.
The set temperature will flash, indicating that it saved your e_o
settings.
o o
6. To change the cooling temperature setting, press the mode o o
button until you will see the word cool flashing on the ooo o
screen.
7. Press the up or down button until you reach the desired temperature set-
ting.
8. Press and hold the away button for about three seconds. The set temperat-
ure will flash, indicating that it saved your settings.
To Next Page
Loading...
