PROGRAMMING THE THERMOSTAT
Setting the sleep temperature
1. Press the sleep button located under the display in the °11 IIo
center. You will see a triangle icon (V) above the sleep o_o
button, o o
2. You will see the heating and cooling temperatures that were o o o o
set at the factory. To use these, just close the door. o_e
3. To change the factory settings, press the sleep button. You o_e
will see the word heat flashing on the screen, o o
4. Press the up or down button on the right side of the dis- ooo o
play until you reach the desired temperature setting.
5. Press and hold the sleep button for about three seconds.
The set temperature will flash, indicating that it saved your e_o
settings, o_o
6. To change the cooling temperature setting, press the mode o o
button until you see the word cool flashing on the screen, o o o o
To Next Page
Loading...
Need help?
General
