Introduction to Carrier sensors
Carrier Sensors CARRIER CORPORATION ©2021
Installation Guide All rights reserved
2
WARNING Disconnect electrical power to the controller or sensor before wiring it. Failure to follow this
warning could cause electrical shock, personal injury, or damage to the device.
CAUTION Do not run sensor or relay wires in the same conduit or raceway with Class 1 AC or DC service
wiring.
• Do not abrade, cut, or nick the outer jacket of the cable.
• Do not pull or draw cable with a force that may harm the physical or electrical properties.
• Avoid splices in any control wiring.
To Next Page
Loading...
