8
Assembling an Array
Assembly and deployment of TRx3210 arrays are carried out one array module at a time or in pre assembled
groups of array modules. Aer installing the SureFly™ hardware kit to each enclosure, attach the T-bar to the top
array enclosure. e TRx3210F comes with preinstalled SureFlyTRx hardware. Each subsequent enclosure can be
pinned at dierent angles to accomplish wide vertical coverage angles and focus sound energy where needed.
1.
2.
2.
2.
1.
1.
2.
1.
1.
Step 2
Installing the T-Bar
Attach assembled T-Bar to rst (top) array enclosure.
At the same time lower side plates of the T-Bar
evenly into the SureFly hardware. Attach the T-Bar
side plates using the bolts, washers and nuts supplied.
Using a torque wrench, tighten the bolts to 40 lbs.
e T-bar side plates must insert between the two
plates of the array module hardware. Align holes and
secure with the included four (2 per side) quick re-
lease pins into both (A) and (B) holes.
Step 1 (skip with TRX3210F preinstalled hardware)
Installing the SureFlyTRx rigging kit.
Each enclosure will require one SureFlyTRx rigging kit. e kit in-
cludes all mounting hardware and quick release pins. Drilling into
the TRx3210 enclosure is not required. All mounting points on the
TRx3210 enclosure have threaded inserts.
Set all quick release pins aside. As shown in the diagrams, assemble
the side panels of the SureFlyTRx kit using the included bolts and
washers. Insert the adjustment plate in-between the two mounting
plates. e lower bolt will function as a hinge. Hand tighten the bolts
and insert the quick release pins as shown. Once the side plates are
aligned by installing the Quick Release Pins into the positions shown,
use a torque wrench to tighten the bolts to 20. lbs. Repeat this pro-
ceedure on the other side of the enclosure. Aer the SureFlyTRx
hardware has been installed on all enclosures, they may be stacked
4 high by making sure both side adjustment plates slide in-between
the mounting plates of the enclosure below. Store pins in the handle
area aer installation.
Tighten bolts to 20 ft lbs
Tighten bolts to 40 ft lbs
To Next Page
Loading...
Need help?
General
