CAS 1560A - Installation & Connection; Load Cell Connection Guide

11
10
REAR PANEL
n INPUT : External input
ZERO key, START key(F08)
n OUTPUT : External output (relay output)
ZERO, LOW, HIGH, FINAL
n LOAD CELL : Port for connecting load cell.
1: EX+ 2: EX- 3: SIG+ 4: SIG- 5: GND
n POWER : POWER ON/OFF
n AC : Only for 220V 50/60 Hz
n SERIAL : RS-232C
INSTALLATION & CONNECTION
Load cell connection
Pin1: Excitation voltage+
Pin2: Excitation voltage-
Pin3: Sense voltage+
Pin4: Sense voltage-
Pin5: Shield
n Connecting method
4Each L/C manufacturer’s or model’s
wire color could be different. In that
case, please note the following
diagram.
n Manufacturer’s wire color
Connector
Company
Pin 1
(EX +)
Pin 3
(EX - )
Pin 5
(SIG +)
Pin 6
(SIG - )
Pin 7
(SHIELD)
CAS RED WHITE GREEN BLUE CASE
KYOWA RED BLACK GREEN WHITE CASE
INTERFACE RED BLACK GREEN WHITE CASE
P.T RED BLACK GREEN WHITE CASE
BLS GREEN BLACK WHITE RED YELLOW
SHOWA RED BLUE WHITE BLACK CASE
SHINKOH RED BLACK GREEN WHITE CASE
TMI RED WHITE GREEN BLUE YELLOW
TML RED BLACK WHITE GREEN CASE
TFAC RED BLUE WHITE BLACK YELLOW
HUNTLEIGH GREEN BLACK RED WHITE CASE