CAS PB Series User Manual

10
4.SETUP MODE
4-1. How to Go to Setup Mode
Make sure that power is OFF. While pressing the ZERO key, press the key. The display shows “U
SEt”. You can select each menu by pressing the ZERO key and change the setting by pressing the
TARE key. If you press ZERO key, you can save current setting and go next mode.
4-2. Set up Mode Table
MENU DISPLAY DESCRIPTIONS
“noSnd”
Do not use printer. (No Send Mode)
“K-Snd” Push the key , Print out. (Command Mode)
“S-Snd” Weight is Stable, Print out. (Stable Mode)
“U-Snd” Print out, continuously. (Continue Mode)
Printer
“C-Snd” Weight is changed, Print out. (Change Weight Mode)
“ AP oFF ”
Do not use Auto Power Off function.
“ AP 10 ”
Power turns to be off automatically when the scale is
not in operation over for 10 minutes.
“ AP 30 ”
Power turns to be off automatically when the scale is
not in operation over for 30 minutes.
Auto Power Off
“ AP 60 ”
Power turns to be off automatically when the scale is
not in operation over for 60 minutes.
“ bL on ”
Use back-light.
“ bL 10 ”
Back-light is on 10 seconds.
“ bL 30 ”
Back-light is on 30 seconds.
Backlight
“ bL oFF ”
Do not use back-light.
Brightness “ 1 ~7 ”
You can set backlight brightness. (Default : 3)
Italic Bold : Default Setting ※

CAS PB Series Specifications

General

Display	LCD
Overload Protection	Yes
Units	g, oz
Interface	RS-232 (optional on some models)
Auto Calibration	Yes
Operating Temperature	10°C to 40°C
Material	Stainless steel platform, ABS housing