OPERATIONS
■Turn on the display by pressing key. Then, the display will show all the segments and
count up "0" to "9". You may stop this automatic counting by pressing the key.
■ When you turn on the display, make sure that platter is empty. Otherwise, display will show
"Err 1", an error of initial zero range. Please refer to "ERROR MESSAGE" section for
more information on page 16
■ When the weight becomes stable the display shows the stable sign ( ○ ) on.
■ You may need to make it "0.00" by pressing key unless the display indicate "0.00"
under the empty platter.
1. Simple Weighing Mode
① Place a commodity on
the platter.
② Remove the commodity
from the platter.
To Next Page
Loading...
