CAS PD-II - 2.8. ECR INTERFACE; 2.8.1 ECR Interface; 2.8.2 ECR Type Selection

15
2.8. ECR INTERFACE
2.8.1 ECR Interface
PD-II can interface with most ECRs by selecting TYPE 0 to TYPE 6.
2.8.2 ECR Type Selection
(1) Make sure that power is OFF. While pressing TARE key, turn on the power. “EcrSEt” is
shown on the display. And then current ECR type is shown on the display as “tYPE-2.
(2) If you select ECR type 5, press the TARE key until the display shows it. (Refer to Table 1.)
(3) To save current ECR type, press the ZERO key.
Table 1
※ Serial Communication
 9600 Baud rate, 7 Data bit, Even Parity, 1 Stop bit
Description
MENU
4-
Bit Parallel RS-232 Serial
ECR-TYPE 0 TEC 4 Digit 4Bit Paralle (New kg)
ECR-TYPE 1 TEC 5 Digit 4Bit Paralle (Old kg)
Most P.O.S, ECRs and Some TEC P.O.S
System
ECR-TYPE 2
SHARP ER-Axxx, ER-A450T, New SANYO
ECRs using RS-232 and others
ECR-TYPE 3 Most P.O.S System
ECR-TYPE 4
CRS, NCR2170, SAMAUNG ER-5100,
ER5115 and Many other ECRs
ECR-TYPE 5
NCI General.
SAMSUNG ER-5100
Most P.O.S Software
ECR-TYPE 6
Universal 4 Bit Parallel
SAMSUNG ER-670