20
CAL 3-4
Function: Weight Calibration)
Used key Display Descriptions
LoAd
Load the weight set in CAL3-3 and press the
setup key.
12345
The current weight value is displayed.
Confirm 'Stable' and press the setup key.
:Span adjustment
- - -
Span adjustment in progress...
Note 1. CAL 3-3 and CAL 3-4 are repeated as many as STEP is set in CAL 3-1.
At this time, the weight value should be set to a value greater than the previous one.
Note 2. Move to CAL-1 if the span adjustment is over with no error.
Note 3. When zero point is low, an error message "ERR24" is displayed.
Note 4. When zero point is high, an error message "ERR25" is displayed.
Note 5. After finishing calibration, press the setup key for 2 seconds or more to convert to the weighing mode.
Note 6. In order to enter the next CAL menu(CAL 7~10), use ‘ZERO’ key to enter the mode
CAL 7
Function: Gravity Adjustment
Used key Display Descriptions
It means you accessed to the menu for the
gravity adjustment.
Gr-CAL
9.XXXX
Set the gravity for the production place.
:Save and
next Menu navigation
: Set value change
: Changing places
Gr-SET
9.XXXX
Set the gravity for the place to use
the product.
Note 1. If the gravity of the indicator production place is different from that of the place to use, the gravity
adjustment can be done using this function.
To Next Page
Loading...
