CAS PDI Series - Test Mode Operations; Test Menu Overview

3
Note 1. To set values to the same as the factory
default for the indicator, press the setup key after setting F99 to 1.
6. Test Mode
6-1. How to Enter the Test Mode
Test mode starts when the power is turned on while pressing key in the front
of the indicator.
Press the number for the test menu as you wish.
To exit the TEST mode, press
key for a long time (turn off the power) and
turn on the power again.
6-2. Test Menu (TEST 1 – TEST4)
Test 1: Key test
Test 2: Display test
Test 3: Load cell test and A/D conversion test
Test 4: RS-232 serial communication test (COM1, COM2)
Test 1
Function: Key test
Used key Display Descriptions
: Test value change
: Test / Move to next menu
KEY 1
When you press any key to test, the number
and code for the key are displayed on the
screen.
<Key List>
Key number Key number Key number Key number
62
60 27 30
4