Startup sequence
User Guide
User Guide
2-17
Admin Website State: The Admin Website is accessible.
Note: The device will be allocated a serving AeMS and possibly an alternate serving
SeGW based on its location. It may re-establish IPSec to the new SeGW at this point if
required. If not, it will contact the AeMS and request configuration information.
11.
Software download in progress.
The Network Extender State
: The device is assigned a AeMS and has been instructed
to download new software.
Admin Website State
: The Admin Website is accessible.
Note: The device will download the newest software and reboot. The process will start
from the first steps again, but the GPS acquisition will occur much faster.
12.
Configuration download in progress.
The Network Extender State
: The device is communicating with the Verizon
management system (AeMS) and may have received new software. It will need to
complete the “Radio Environment Scan” before receiving additional configuration
parameters.
Admin Website State
: The Admin Website is accessible.
Note: During the REM scan process, if no adjacent neighbor Network Extenders or
Macro cells are detected, the Verizon Management system (AeMS) will then provide
the configuration solely based on the GPS location.
13.
Operational status.
The Network Extender State
: The device is in normal in-service operation and has
completed all steps.
Admin Website State
: The Admin Website is accessible.
Note: If the Alarm LED state is Red, this means an alarm condition has occurred. In
this case, please refer to Chapter 5, Troubleshooting for more information on alarm
codes.
To Next Page
Loading...