Startup sequence
Network Extender 3
User Guide
2-16
Note: This status details that the Network Extender has attempted to communicate
with the SeGW.
7.
Successfully reached the Initial SeGW (“Successfully reached the Initial
network”).
The Network Extender State
: The device has contacted the initial SeGW successfully.
Admin Website State
: The Admin Website is accessible.
Note: Status details that the device can communicate with the SeGW, but the IPSec
tunnel is still not established at this point.
8.
VPN setup to Initial SeGW completed (“Authentication to Initial Network
completed successfully”).
The Network Extender State
: The device has brought up the IPSec tunnel with the
initial SeGW.
Admin Website State
: The Admin Website is accessible.
Note: This confirms that the device has set up a VPN connection with Verizon's
network.
9.
Authentication failure during IPSec tunnel setup to Initial SeGW (“Authentication
failure to Initial Network. Unit is not provisioned. Please contact Verizon Wireless
Customer Care for further assistance”).
The Network Extender State
: The device has failed to set up a VPN tunnel with the
initial SeGW with an explicit “Authentication Failure.”
Admin Website State
: The Admin Website is accessible.
Note: This details that the device been notified it failed authentication with the Verizon
Authentication server.
10.
Connection with the management system (“Connecting to Initial Management
Server”).
The Network Extender State
: The device acquired location information and is
connecting with the AeMS.
To Next Page
Loading...