Casadei ProWoodTech E550 - Page 76

E550 - E550 CR - E550 PM - E550 PM CR Automatic Single-Side Edgebander Rel. 1.1.1
76
3.7.1 ETR-45 END TRIMMING-BLADE UNIT X RADIUS TRIM
Technical specications tcniche
End trimming-blade motor N. 1 200 Hz – 12,000 rpm – 0.22kW
Straight trimming blade N. 1 Ø 100
Radius trim blade N. 2 Ø 79.2 (RH and LH)
Extraction hood N. 1 Ø 60
Unit description
The ETR-45 end trimming-blade unit automatically removes excess material from the front and rear
edges.
This function is subject to setting the straight cut at 0° or radius cut.
For each setting, the following choices can be made:
• End trim front edge only
• End trim rear edge only
• End trim front and rear edges
The unit consists of a high-frequency motor A g. 1.1 equipped with a triple-blade unit: the central
blade C g. 1.1a for the 0° cut, and the side blades D g. 1.1a for the radius cut.
The alignment of the blades with the panel is ensured by a sliding copy lathe B g. 1.1a with stop
system.
The motor and the copy lathe slide on linear guides with ball-bearing runners to ensure precision,
uidity and reliability.
Operation
The ETR-45 end trimming-blade unit is normally not involved in panel machining and transit. It star-
ts operating when the feed track (button 6) is started only if the cycle (button 3) and motor rotation
(button 8) have been pressed on the control panel.
Choice
By keeping (button 3) pressed for 4 seconds, the cut type conguration menu can be accessed. Now
press (button F) or (button B) to change the choice:
• Front and Rear
• Rear only
• Front only
Press (button A) to conrm. Now the display screen will ask you to choose the type of edge nish.
Press (button F) or (button B) to change the choice:
• Straight
• Radius
Press (button A) to conrm.
NB. If the “radius” function has been started, the LED of (button 3) will ash.