Casadei ProWoodTech E550

To Next Page

To Previous Page

E550 - E550 CR - E550 PM - E550 PM CR Automatic Single-Side Edgebander Rel. 1.1.1

Problems, causes and remedies

PROBLEMS POSSIBLE CAUSES REMEDIES

The chain moves but the mo-

tors are at a standstill

Button 8 not activated

(Fig. 3.1.1).

Inverter U1 off

Activate button 8 (Fig. 3.1.1)

Check fuses FU6.

Cutting is not perfect Inadequate sharpening

Glue residues on blades

Incorrect tting of blades

Millers not balanced, causing

vibrations

Copiers dirty

Insufcient vertical pressure

Panel damaged

Edgeband damaged

Reset the alarms (see chapter

on the electrical panel)

Sharpen/replace the blades

Clean the blades

Check and reassemble the

blades

Check blade assembly, balan-

ce millers

Adjust the copier scrapers

Adjust vertical pressure

Adjust vertical copying

Adjust frontal copying

Adjust trimmers according to

edgeband thickness

3.9 VERTICAL NESTING COPIERS FOR FLUSH TRIMMER UNIT (OPTIONAL)

Suitable for work on panels with recesses to hold hardware and on panels with acute corners (min. 60°).

Both upper and lower copiers are tted with 3 bearings to guarantee 3 support points.

The unit is pre-adjusted in the factory, and requires no further adjustment after tool changes. Follow

the instructions given in the ush trimmer section.

NOTES

______________________________________________________________________________________

Related product manuals