Cascade E-Series - Clamp Removal

215204 Rev. 1 25
ERVICE
S
CL0309.ill
5.1 Clamp Removal
1 Position the Clamp's arms to the width of the frame.
2 Disconnect and plug the hydraulic supply hoses to the
Clamp. Tag hoses for reassembly.
3 Disconnect the lower hooks:
Quick-Change Hooks – Remove the locking pins and
drop the hooks into the unlocked position. Replace the
pins in the lower holes. For reassembly, remove the pins
and slide the hooks up to the locked position. Replace
the pins in the top holes.
Bolt-On Hooks – Remove the capscrews and mounting
hooks. For reassembly, tighten the capscrews as follows:
Class II/III Mounting – 165 ft.-lbs. (225 Nm).
4 Lower the Clamp onto a pallet. Tilt the mast forward and
lower the carriage to disengage the upper hooks.
5 For Clamp installation, reverse the above procedures
except as follows:
• Refer to Section 2 for complete installation procedure.
WARNING: Before removing hydraulic
lines, relieve pressure in the hydraulic
system. Turn the truck off and open the
truck auxiliary control valves several times
in both directions.
CL0246.ill
cascade
®
C-675514-1
RC0367.ill
RC0368.ill
ADJUST
Sideshift Left
Sideshift Right
Open
Clamp
Back (driver's) View
2
4
3
QUICK-CHANGE LOWER HOOKS BOLT-ON LOWER HOOKS
Guide
Left Hook
Locking Pin
(Unlocked Position)
Carriage Bar
Left Hook