215204 Rev. 1 1
I
NTRODUCTION
1.1 Introduction
This Manual provides the Installation, Periodic Mainte-
nance, Troubleshooting, Service and Specifications for
Cascade E-Series Clamps.
E-Series Clamps are designed for three-shift-a-day
continuous-duty operations with minimal maintenance.
They offer exceptional visibility for the lift truck driver and
provide optimized clamp force and load handling.
In any communication about the Clamp, refer to the
product I.D. number stamped on the nameplate as shown.
If the nameplate is missing, the numbers can be found
stamped on the back of the baseplate.
IMPORTANT: All hoses, tubes and fittings on E-Series
Clamps are JIC.
NOTE: Specifications are shown
in both U.S. and (Metric) units.
1.2 Special Definitions
The statements shown appear throughout this Manual
where special emphasis is required. Read all WARNINGS
and CAUTIONS before proceeding with any work.
Statements labeled IMPORTANT and NOTE are provided
as additional information of special significance or to
make the job easier.
CAUTION - A statement preceded by CAUTION is
information that should be acted upon to prevent
machine damage.
IMPORTANT - A statement preceded by IMPORTANT is
information that possesses special significance.
NOTE - A statement preceded by NOTE is information
that is handy to know and may make the job easier.
WARNING - A statement preceded by
WARNING is information that should be
acted upon to prevent bodily injury. A
WARNING is always inside a ruled box.
45E-BC-005
cascade
LIFT TRUCK ATTACHMENT
ATTACHMENT CAPACITY
SERIAL
NUMBER
CATALOG
NUMBER
ADDITIONAL
EQUIPMENT
ADDITIONAL
EQUIPMENT
ADDITIONAL
EQUIPMENT
FOR TECHNICAL ASSISTANCE, PARTS AND SERVICE
CONTACT:
1-800-227–2233
PORTLAND, OREGON USA
WEIGHT
LBS.
POUNDS
AT
INCH LOAD
CENTER
CAPACITY OF TRUCK AND ATTACHMENT COMBINATION
MAY BE LESS THAN ATTACHMENT CAPACITY SHOWN
ABOVE. CONSULT TRUCK NAMEPLATE.
RECOMMENDED SYSTEM PRESSURE – 2000 PSI
MAXIMUM SYSTEM PRESSURE – 2300 PSI
cascade corporation
T
T
c
S/N 45E-BC-005
CL0412.ill
Nameplate
To Next Page
Loading...